Removing The Rod From The Pushbuddy - Kummert PushBuddy Bedienungsanleitung

Fold the movable part of the Push-
Buddy upwards. Engage the clamping
®
hooks on both sides of the pivots and
press the lever down.
Connect the camera to the rod (see camera operating instructions) and activate it via the
software.
WARNING
Risk of injury by crushing or clamping!
The device has moving components. When adjusting these components, there is a risk
of jamming or crushing parts of the body.
• Follow the instructions in this manual carefully.
• Never reach into the area where the components are moving when adjusting the
components.

Removing the rod from the PushBuddy

Lift the lever upwards. Make sure that the lever is no longer engaged with the pivots and
unfold the movable part of the PushBuddy®. Take the back part of the rod, push it a little bit
forward and then to the side, to take it out of the roll. Pull the rod out of the PushBuddy®
and wind it back into the reel (see reel operating instructions).
WARNING
Risk of injury by crushing or clamping!
The device has moving components. When adjusting these components, there is a risk
of jamming or crushing parts of the body.
• Follow the instructions in this manual carefully.
• Never reach into the area where the components are moving when adjusting the
components.
EN
®
43 43