Setting The Pipe Diameter - Kummert PushBuddy Bedienungsanleitung

Setting the pipe diameter

In order for the clamping device to function optimally, it must be adapted to the inspecting
pipe diameter. To clamp the PushBuddy
i.e. 100-150. If the PushBuddy
corresponding diameter.
Pull out the locking pin of the clamping
mechanism and slide it up or down until
the desired diameter range can be read
in the cut-out. To adapt the device for
DN300, pull out the pin of the clamping
mechanism and move it downwards,
turn it over and put it back in place.
Position it so that 300 can be read in the
cut-out.
Always make sure that the pin is proper-
ly engaged.
Pipe wall or
DN100 - DN150
EN
to a pipe wall, select the smallest possible setting,
®
is to be clamped to the inner side of the pipe, adjust the
®
DN200 - DN250 DN300
41 41