Technical Specifications - Velleman CAMIP5N Bedienungsanleitung

Camera not available via Internet
• Possible reasons may include:
o ActiveX controller is not installed/working properly.
Note: a standard Firefox browser does not support ActiveX. However there are plug-inns
available on the Internet.
o The port of the IP camera is blocked by a firewall or anti-virus software. In this case, try
using a different port number.
o Port mapping failed. Either enable UPnP (via UPnP Settings) or edit the routers Virtual
map list (refer to the user manual of your router).
11.

Technical specifications

sensor
lens
minimum illumination
resolution
built-in pan/tilt
supported network protocols
wired connection
wireless connection
network connection
audio
video
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product and the latest version of this user manual, please visit our
website www.velleman.eu. The information in this manual is subject to change without
prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic
medium or otherwise without the prior written consent of the copyright holder.
13.12.2010
left/right
up/down
standard
supports 3 methods
compression format
frame rate
resolution
CAMIP5N
¼" colour CMOS sensor
3.6mm / F2.4
0.5 lux (IR LEDs off)
640 x 480 pixels (300 000 pixels)
controllable through internet
300°
120°
TCP/IP, UDP, IMCP, SMTP, HTTP, FTP, DNS, DDNS,
DHCP, PPPoE, GPRS
Ethernet 10/100 Base-T and RJ45
IEEE 802.11b/g
supports WEP, WPA & WPA2 encryption
fixed IP, DHCP, PPPoE
supports DHCP, installs the IP address automatically
(plug-and-play network)
built-in microphone
MJPEG
15 FPS (VGA), 30 FPS (QVGA)
640 x 480 (VGA), 320 x 240 (QVGA)
110 x 100 x 108mm
±333g
18
©Velleman nv