Installer Information - Swim & Fun ECO 1400 Bedienungsanleitung

UK
implied warranty of fitness for a particular purpose and saleability. We expressly disclaim all liability
for consequential damage, accidental damage, indirect loss or loss related to a breach of the ex-
pressed or implied warranty.
This warranty gives you specific legal rights, which may vary by country.
Complaints
In the event of a complaint, the dealer must be contacted and a valid purchase receipt presented.
IMPORTANT!
If you need technical help – contact Swim & Fun Scandinavia ApS
on the service hotline:
DK-telephone +45 7022 6856 Monday – Friday from 09.00 – 15.00.

10. Installer information

Function
Protection against too
low or too high ambient
temperature
Failure of the water tem-
perature sensor
Failure of the ambient
temperature sensor
General error
Water flow failure
Protection against water
pressure
MV-1400-10-2019 . © All rights reserved Swim & Fun Scandinavia ApS
Code Reason
Ambient temperature is out of tem-
P0
perature range, 7°C-42° C.
Short circuit/open circuit of the
P1
water temperature sensor.
Short circuit/open circuit of the
P2
ambient temperature sensor.
Water flow failure or pressure pro-
EL
tection.
1. Water flow switch failure.
FL
2. No or insufficient water flow.
1. The pressure is too high or
too low.
PL 2. Failure or disconnected high/
low pressure switch.
3. Gas leakage
Solution
Before restarting the heat pump
make sure that the ambient tempera-
ture is above 9°C and below 40°C.
Replace the water temperature sen-
sor.
Replace the ambient temperature
sensor.
1. Change the water flow switch.
2. Check the water pump or if the
system is clogged.
Consult with a service technician.
79