Wiring; Initial Operation - Swim & Fun ECO 1400 Bedienungsanleitung

4.6. Wiring

Power Supply Wiring
Control Box Wiring

5. Initial operation

Note
In order to heat the water in the pool (or in the hot tub), the filter pump must be in oper-
ation and the water must circulate through the heat pump at a minimum of 2,500 litres/
hour. Otherwise, the heat pump will not start up.
After all connections have been made and checked, the following procedure must be carried
out:
Switch on the filter pump. Check for leaks and check that the water circulates from and to the pool.
Connect the heat pump to the power outlet and turn on the On/Off button. The heat pump will start
up after the built in time delay (see below).
After a few minutes, check whether the exhaust air from the heat pump is cool.
When the filter pump is turned off, the heat pump will also automatically turn off. If this is not the
case, the flow switch needs adjusting.
Allow the heat pump and the filter pump to run 24 hours a day until the desired water temperature
is reached. The heat pump will stop by itself when the temperature has been reached. After this,
the heat pump will start automatically (so long as the filter pump is running) whenever the swim-
ming pool water temperature drops 2 degree below the set temperature.
Note
Depending on the initial temperature of the water in the swimming pool and the air
temperature, it may take several days to heat the water to the desired temperature. A
good insulating thermal cover is essential and will reduce the required heating time sig-
74
1) Connect the power sup-
ply wire to cable connector
(10.3 part nr. 13) as shown
in the picture.
2) Fix the other side of the
cable on joints inside the
electric box (10.3 part nr.
25).
MV-1400-10-2019 . © All rights reserved Swim & Fun Scandinavia ApS
UK
If you are the own-
er of a control box.
Connect to the heat
pump by wiring what
is marked in red.