Targus ACP50EU Handbuch Seite 10

Connecting the Docking Station to Your
Computer
After installing the docking station software, you are
ready to connect the docking station to your computer. To
do this:
1 Connect the supplied AC power adapter to the AC
2 Connect one end of the USB cable to the docking
Installing the Default Device Drivers
Once you connect the docking station to your computer,
the default drivers begin installing for each of the ports.
Some hardware devices may prompt you to install the
drivers.
To install the drivers:
1 Select Install the software automatically (Recom-
2 Click Finish and repeat as needed for each device.
3 Restart your computer.
Downloaded from www.Manualslib.com
Targus Mobile Docking Station with Video
power jack on the docking station.
station and the other end into an available USB 2.0
port on your computer.
NOTE: The docking station will not function properly without
the AC adapter plugged into an AC outlet.
Do not connect any devices to the docking station until the
installation is completed.
mended) and click Next.
The Found New Hardware Wizard program begins
installing the hardware drivers.
The Completing the Found New Hardware Wizard
screen appears.
manuals search engine
10