Electrical Connection - Novy 1801 One Power Montageanleitung


The unit is by default set to recirculation.
Disable the recirculation program in case of
exhaust to the outside (5.2).

4. ELECTRICAL CONNECTION


The installation and connection to the elec-
tricity grid shall only be carried out by an
expert (electrician) who is familiar with the
required standards.
The junction box is to be found at the bottom of the
cooking plate. Use a screwdriver to open the cover and
place this in the 2 grooves before the arrows.
Disable the main switch of the fuse concerned before
connecting the unit.
Connect the unit in accordance with the table and dia-
gram below.
Mains Connection
Wiring diagram
230V 1 phase + N
50/60Hz
230V 3 phases
50/60Hz
400V 2 phasen + N 4 x 4 mm²
50/60 Hz
400V 3 phasen + N 5 x 4 mm²
50/60 Hz
Supply cord Circuit
braker
3 x 6 mm² 32 A
4 x 6 mm² 20 A
16 A
16 A
Attention! Properly put through the wires and tighten
the screws.
We will not accept any responsibility for accidents resulting
from a poor or wrong connection or accidents that may
occur with units without or with a defective earthing.
5. COMMISSIONING
5.1 Mount the glass plate onto the tower
Press 2 sec. on key
the tower assembly from the cooking plate by pulling it
up and place the tower on the table top. Take the loose
glass plate and place it with a turning movement onto
the tower (drawing 9 and 10).
5.2 User modes
The unit is by default set for operation in the recirculation
mode. If an exhaust to the outside is used anyway, disable
the indicator for saturated recirculation filter as follows:
Change setting for exhaust duct to the outside:
Only disable the programming when mounting an exhaust
duct to the outside.
This setting can only be changed when the tower has been
disabled and therefore is in the most downward position.
Simultaneously press the key combination [
] for 3 seconds until the LED beside the
Setting back to recirculation:
Simultaneously press the key combination [
]for 3 seconds until the LED beside the
for 3 seconds
5.3 Limitation maximum power induction hob
(only for 1801 One Power)
The hob can be equipped with a power limitation. If
you reach the maximum power it will be impossible to
increase the power on the different cooking zones and
a beep signal will sound. This limitation is set at 7400W
(32A) by the factory but it is possible to change it to
4800W (20A) or 3000W (12A).
Before beginning the procedure:
− Make sure there is no more pot on the hob
− Disconnect the appliance from the grid by removing
the fuse or turning the circuit breaker off.
− Reconnect the table to the grid
− Start the procedure within 2 minutes after reconnecting
the hob to the grid
− Make sure all cooking zones are off.
18
to move the tower up. Take
], [ ], [
blinks 3 times
], [
lights up
], [