Pkm GK212.4 A++N Bedienungsanleitung Seite 26

your appliance unless they are recommended by the manufacturer of your
refrigerator.
19. Do not put any heat-radiating appliances onto your appliance.
20. Do not install the appliance in a place where it may come in contact with
water/rain; otherwise the insulation of the electrical system will be damaged.
21. Do not put a water-boiler or vases onto your appliance. The electrical
components of your appliance can be seriously damaged by water over-boiling
or spilled water.
22. Do not use any steam cleaners to clean or defrost the appliance. The steam can
get into contact with the electrical parts and cause an electrical short. RISK OF
ELECTRIC SHOCK!
23. Never use mechanic devices, knives or other sharp-edged items to remove
encrusted ice inside the appliance. RISK OF ELECTRIC SHOCK caused by
damaging the interior of the appliance.
24. Children must never play with the appliance.
25. If you decommission your appliance (even temporarily), ensure that
children cannot get into the appliance. Strictly observe the corresponding
safety instructions numbers. 1 and 4, chapter D
26. Strictly observe the instructions in chapter INSTALLATION.
1. The condenser and the compressor, located at the rear of the appliance, can
reach high temperatures during ordinary operation. Carry out the installation
according to this manual. An insufficient ventilation of the appliance will
impair its operation and will damage the appliance. Do not cover or block the
ventilation slats at any time
2. Do not touch the extremely cooled surfaces with wet or damp hands, because
your skin may stick on these surfaces.
3. Do not store any gassy beverages or water bottles in the freezing compartment
of the appliance as their containers can explode.
1. When you move the appliance, hold it at its base and lift it carefully. Keep the
appliance in an upright position.
2. Do not tilt the appliance more than 45
3. If the appliance is transported in a horizontal position, some oil may flow from
the compressor into the refrigerant circuit.
4. Leave the appliance in an upright position for 4-6 hours before you switch it on
to ensure, that the oil has flowed back into the compressor.
5. Never use the door for moving the appliance as you will damage the hinges.
6. The appliance must be transported and installed by at least two persons.
ECOMMISSIONING
CAUTION!
NOTICE
0
.
26
, ultimate