Installation; Dip Switch Setup - Samsung SCC-C7478 Benutzerhandbuch

DIP SWITCH SETUP

Before you install the camera, you should set the DIP
switches to confi gure the camera ID, communication
protocol.
❖
Camera ID Setup
ON
ON
1 2 3 4
• ID number of camera is set using binary number.
The example is shown bellow.
Pin 1 2
ID Value 1 2
ex) ID=5 on off
ex) ID=10 off on
• The range of ID is 0~255. Factory default of
Camera ID is 1.
• If you want to control a certain camera, you must
match the camera ID with Cam ID setting of DVR
or Controller.
5 6 7 8
3 4 5 6 7 8
4 8 16 32 64 128
on off off off off off
off on off off off off

Installation

❖
Communication Protocol Setup
ON
ON
1 2 3 4
• Select the appropriate Protocol with DIP switch
combination.
Switch State
Pin1 Pin2 Pin3
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
• If you set the protocol as Auto Protocol, camera will
automatically recognize the kind of Protocol.
• If you want to control using DVR or system keyboard,
their protocol must be identical to camera. Otherwise,
you can not control the camera.
• If you changed camera protocol by changing DIP S/W,
the change will be effective after you reboot the camera.
• Factory default of protocol is "Auto" Protocol
❖
Communication Baud rate Setup
ON
ON
1 2 3 4
• Select the appropriate Baud rate with DIP switch
combination.
Switch State
Pin5 Pin6
OFF OFF
ON OFF
OFF ON
ON ON
OFF OFF
• Factory default of Baud rate is "9600 BPS"
5 6 7 8
Protocol
Pin4
OFF Auto Protocol
OFF PELCO-D
OFF PELCO-P
OFF SAMSUNG
5 6 7 8
Protocol
Pin7
OFF 2400 BPS
OFF 4800 BPS
OFF 9600 BPS
OFF 19200 BPS
ON 38400 BPS
English – 9