Specifications; Troubleshooting - Miro Td271 Handbuch

S
PECIFICATIONS
LCD Type
Color Filter
Colors
Glass surface
Viewing
Angles Left / Right
(CR>10) Up / Down
Contrast Ratio Typ.
Typ.
Luminance of White
Response Time Typ .
Compatibility PC
Refresh Rate Max.
Connectors Input Signal
Power Input
Consumption
Display Area Max.
Operating Temperature
Humidity
Altitude
Storage Temperature
Conditions Humidity
Dimension
Weight Net
14
17" diagonal viewable screen
TFT (Thin Film Transistor),
Active Matrix Panel, 0.264mm pixel pitch
R, G, B vertical stripe
up to 16.2 mio. colors
Anti-glare coating
75° / 75°
60° / 65°
450 : 1
250cd/m²
25ms
IBM XT, AT, 386, 486, Pentium or PS/2
and compatibles (from VGA up to
1280 x 1024 @ 75 Hz NI.)
1280 x 1024 @ 75Hz NI
(60Hz for optimal display)
15-pin D-SUB
AC 90-264V 50-60Hz
40 watts (Maximum)
338mm (H) x 270mm (V)
32°F to 104°F (0°C to 40°C)
20% RH to 90% RH (no condensation)
To 10,000 feet
-14°F to 104°F (-20°C to 40°C)
5%RH to 90%RH (no condensation)
459mm(W) x 467mm(H) x 165mm(D)
7.5kg
T
ROUBLESHOOTING
No power.
ü
Flip the power switch ON. The Power LED turns on.
ü
Make sure AC power cord is securely connected to the power jack
and to a power outlet.
Power on but no screent image.
ü
Make sure the video cable attached with this monitor is tightly
secured to the video output port on the back of the computer.
ü
Adjust the brightness and contrast.
Image is unstable, unfocused.
ü
Use "AUTO-TUNE" to adjust automatically.
ü
If the image is still unstable after "AUTO-TUNE" processing,
please adjust "PHASE" manually to get image focused.
ü
Check whether the resolution or refresh rate in windows display
setting is beyond supported range(please refer to the specification
of supported mode).
Flickering.
ü
Not enough power is being supplied to the miro TD271 Monitor.
Connect the miro TD271 Monitor to a different outlet. If a surge
protector is being used, there may be too many devices plugged in.
ü
See Timing Guide in this manual with a list of refresh rates and
frequency settings showing the recommended setting for the
miro TD271 Monitor.
Wrong or abnormal colors.
ü
If any colors (Red, Green, or Blue) are missing, check the video
cable to make sure it is securely connected. Loose pins in the
cable connector could cause a bad connection.
ü
Connect the miro TD271 Monitor to another computer.
ü
Check the graphics card for proper sync scheme (or sync
polarities) to match the miro TD271 Monitor's specifications.
15