Disposal - Zipper Maschinen ZI-STE1100IV Betriebsanleitung

12.9

Disposal

Do not dispose the machine, machine components fuel and oil in residual waste. Contact your local
authorities for information regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old.
13 TROUBLE SHOOTING
Trouble
Engine does not start
Engine starts and is stalled
immediately
Machine works with interruptions
Oil alarm indicator light flashes
Oil alarm indicator light glows
Output indicator light interval flash 1x
Output indicator light interval flash 2x
Output indicator light interval flash 3x
Output indicator light interval flash 4x
Should you in necessary repairs not able to properly to perform or you have not the
prescribed training for it always attract a workshop to fix the problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STE1100IV
Possible cause
 Incorrect starting sequence
 Dirty air cleaner
 No fuel supply
 Fault in the fuel line
 Engine flooded.
 Spark plug connector not placed on.
 No ignition spark
 Fuel cock closed
 Engine oil to few
 Incorrect idle adjustment
 Carburetor incorrectly adjusted
 Spark plug fouled
 Check oil level
 To less or no oil
 Low voltage protection activated
 High temperature protection activated
 Overload protection activated
 Short circuit protection activated
N O T I C E
Solution
 Observe the correct starting
sequence
 Clean/replace air cleaner
 Refuel
 Check the fuel line for kinks or
damages
 Screw off, clean and dry the
spark plug. Then pull the
cranking rope several times and
reinstall the spark plug
 Place on the spark plug
connector
 Clean/replace spark plug
 Check ignition cable
 Open fuel cock
 Check engine oil
 Contact customer service
 Contact customer service
 Clean/replace spark plug
 Check spark plug connector
 Fill engine oil
 Fill engine oil
 Engine speed to low
 Cool down the engine
 To big loads
 Check loads
29