Beko GN162320 Bedienungsanleitung Seite 33

Using the product
When the ice dispenser does not work
properly
If you do not remove ice cubes for a long time, they
will cause formation of ice chunks. In this case, please
remove the ice stock reservoir in accordance with the
instructions given above, seperate the ice chunks,
discard the inseparable ice and put the ice cubes back
into the ice stock reservoir. (Figure 4)
When ice does not come out, check for any ice stuck
in the canal and remove it. Regularly check the ice
canal to clear the obstacles as shown in the figure 5.
When using your refrigerator for the first time or when
not using it for an extended period of time Ice cubes
may be small due to air in the pipe after connection,
any air will be purged during normal use.
Discard the ice produced for approximately one day
since the water pipe may contain the contaminants.
Caution!
Do not insert the hand or any other object into the ice
canal and blade since it may damage the parts or hurt
the hand.
Do not let the children hang on the ice dispenser or the
ice maker since it may cause an injury .
To prevent dropping the ice stock reservoir use both
hands when removing it.
If you close the door hard, it may cause water spilling
over the ice stock reservoir.
Do not dismount the ice stock reservoir unless it is
necessary.
If there is a lockout (ice does not come from the
refrigerator) while taking broken ice, try to take cubed
ice.
Then it will be suitable for taking broken ice again.
While taking broken Ice, cubed ice may come first.
There is a case of coming cubed ice while taking
broken ice.
Operating the product Freezer door on front of the ice
machine can create a light snow and film layer.
This is normal, it is recommended to clean without
waiting for a long time.
The water is filled with water over time in the lower
zone of the water dispenser. It is recommended to
clean the water within this zone periodically.
While the ice falls from the ice storage reservoir, the
sound is normal and does not indicate that the product
is problematic.
The blade mechanism inside the ice bank is sharp and
can cut your hand.
If the ice dispenser does not provide ice, the ice may
be stuck together, remove the tank and clean it again.
Ice type cannot be changed on the display when the
ice trigger is pressed to obtain ice. Release the trigger,
change the ice type on the display and obtain ice
again.
32 / 39 EN
Refrigerator / User Guide