CASO DESIGN TC 2100 Thermo Control Original Bedienungsanleitung Seite 42

External Thermometer – control of temperature inside the cooking vessel:
Connect the thermometer at the lower right side of the device and hang it into the
cooking vessel. When the thermometer is connected then it measures and controls
continuously the temperature according to the desired temperature setting. After start of
heating process the display shows the actual temperature. If you briefly press on button 3
(temp) again then the set-point temperature will be shown.
The LED temp lights continuisly, when the function for control of temperature inside the
cooking vessel is selected.
With the + / - keys you can change the setting in range from 40 – 160 °C.
(temperature stages 40 – 160 °C in 1 ° C – steps)
External Thermometer – control of the desired core temperature in the food:
 Connect the thermometer at the lower right side of the device and stick it in the food.
Press button 3 (temp) for 3 seconds. The preset temperature stage of 65 ° C will be
shown in the display.
 The LED temp flashes, when the function control for the desired core temperature is
selected.
 With the + / - keys you can change the setting in range from 40 – 160 °C and so you
can control the core temperature. (temperature stages 40 – 160 °C in 1 ° C – steps)
 You can switch to power mode with button 4 or to direct functions with button 5, to start
the cooking process.
 Please note that the two functions of level and temperature can be chosen as
alternative. You can either work with the power levels or with the temperature stages.
The most recently selected function is active.
 By pressing button 3 the desired set-point temperature is displays and can be
changed.
 When the desired set-point temperature is reached, the heat supply is stopped and the
display shows "END".
 In addition you can control the cooking time with the timer:
a) If the desired core temperature is reached but the programmed time has not yet
expired, then the heat supply will be stopped and the display shows "END".
b) If the programmed time is reached, but the desired core temperature was not yet
reached, then the device switches off automatically.
Please note
► In case of grilling or cooking deep fry food we would advise you to use the function
"Temperature" as in this case you can use temperatures up to 240°C.
42