Symbol Explanation; Declaration Of Conformity - CANGAROO Easy Check Manuelle Bedienungsanleitung

The display shows this message because of many reasons. Please, take a look at the above list with the main
possible problems:
Reasons, the display shows the message "Lo"
Temperature measurement is difficult from hair or sweating.
Temperature measurement is difficult from air flows or sharp
changes in environment temperature.
Successive measurements of the temperature are too close
one after another and the thermometer do not have time to
Measurement area is away from the thermometer.
Symbol
IP22
Protected access with fingers to dangerous parts and against vertical falling of water drops, when it is tilted up to
DISPOSING: Do not throw this product with household waste. Collect separately, because special disposal of
SN
Easy Check is intended for using in electromagnetic environment, specified below. The client or user of JXB-183 must be
Immunity test
Electromagnetic discharge
(ESD) IEC 61000-4-2
Electrical fast transient,
explosive IEC 61000-4-4
restart.

SYMBOL EXPLANATION

DECLARATION OF CONFORMITY

Manufacturer guide and declaration – electronic immunity
sure that the product is used in such environment.
IEC 60601 level test
± 6 kV contact
± 8 kV air
± 2 kV за power lines
± 1 kV for input-output lines
Ensure that there are no obstacles or moisture before
temperature measurement.
Ensure that there are no air flows around the area, in which
the temperature is measured, this can affect the infrared
Leave interval 3-5 secs. Between measurements;
recommended is pause for 15 sec.
Measure the temperature on recommended distance
(around 3-5 cm, 1.2 ~2.0 inches).
Explanation
Trade mark.
IEC 60417-5333, type attached part BF
IEC 60417-5031, Direct current
15 °C
Directing to the instruction/Manual.
those kind of waste is required.
Specific serial number.
Level of compliance
± 6 kV contact
± 8 kV air
NOT APPLICABLE
Advise
reading.
Electromagnetic environment -
guide
Floors must be wooden,
concrete or ceramic tiles. If the
floors are covered with synthetic
materials, relative humidity must
be at least 30 %.
The quality of the basis power
must be this of typical trade or
hospital environment.
19