Technical Characteristics - CANGAROO Easy Check Manuelle Bedienungsanleitung

Berührungsloses infrarot-thermometer

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

 Additional usage:

Easy Check can be used both for temperature measuring in baby feeding bottle and temperature of bath tub water (using

mode for surface temperature measuring) or room temperature (using room mode).

INSTRUCTIONS FOR USING

1.Put the batteries in the compartment correctly according its polarity.

2.While using this for the first time or when putting new battery, pls wait for 10-15 minutes for heating the device. This will

allow to the device to acclimate to the room temperature.

3.Press the on/scan button, point the device to the forehead (look diagram for pointing the thermometer), on distance from 3

to 5 cm. press the button ON/ Scan standby mode and the measuring will finish then the temperature shows itself on the

display or a sound is issued.

4. Measuring time is one second. Note: Do not change the position of the thermometer before measuring to be

finished.

5.Before temperature measuring, ensure that you have removed the hair or sweating from the forehead.

MENU SETTINGS AND FUNCTIONS

1. Turning the device on:

Press the ON/ Scan button, after second, the panel in the display will be in standby mode with signs

„----°C" и „---°F". Then

press the ON/SCAN button once more and the result will show up automatically after 1 second. If you do not use the

thermometer anymore, it will turn off automatically after 30 seconds.

2. Mode switching

а. Press the button "MODE" and the display will show: Body

....°C

b. Press the button "MODE" again and display will show : Room ...°C

c. Press again the button "MODE" and display will show: Surface Temp....°C

Note: The thermometer is set by default on „BODY" mode.

IMPORTANT!

Surface temperature differs from the internal temperature of human body. For measuring the body temperature,

always use „BODY" mode. Please, ensure that you have choose "SURFACE TEMP" mode only for reporting the

external area.

3. In turned on state, press the

button,

°C/°F", to switch between Celsius and Fahrenheit.

4. In turned on state, press the button "MEM" (Memory), which will show the last measured temperature and will show last

32 measurements.

If again, in turned on state, you press the button "MEM" and hold it for 5 seconds, all data will be deleted. After this press

again „MEM" button and the display will show „CLr".

5. In tuned on state, press button „

", to activate or deactivate the alarm. When the display shows "ON", this means the

alarm is activated. When the display shows "OFF" , this means that the alarm is deactivated.

6. Device calibration though menu F4

When there is difference between Easy Check and mercury thermometer, you believe that the mercury thermometer is more

accurate but not comfortable for using. You can use calibration function to tune Easy Check and to receive the value, same

as this on the mercury thermometer. Furthermore, when you use Easy Check for people with different skin color (for

example from yellow, white or black race), you can also use calibration.

 Calibration instructions

1.In turned on state, press the buttons "MODE" and „°C/°F" at the same time for 3 seconds. The display will show: "F4".

2.Press button "MODE", to increase with 0.1 °C, press „°C/°F", to decrease with 0.1 °C.

3.Press "MEM" button, to keep the settings.

4.In case of seasonal or ecological changes, a check and device regulation.

 Battery change:

Display: when LCD display shows this symbol „

", it means batteries are exhausted.

Open the cap and replace batteries, as you be careful to keep the right polarity, when

placing new batteries. An error with this action can lead to damage of the device and

warranty canceling. Never use rechargeable batteries. Use only single use batteries.