Taski swingo 755B Power Bedienungsanleitung Seite 95

Service intervals
TASKI machines are high-quality machines that have been
checked for safety in the factory and by authorized inspectors.
Electrical and mechanical parts are subject to wear and aging
after a longer period of use.
• In order to maintain operational safe-
ty and readiness for use, the ma-
chine must be serviced whenever the
maintenance indicator lights up (fac-
tory setting is 450 working hours) or
at least once a year.
Notice:
In case of extraordinary use and/or insuffi-
cient maintenance, shorter intervals are
required.
Service center
Please always indicate the type and number of the machine
whenever you contact us for order placing or in case of mal-
functions.
The required data are provided on the nameplate of your ma-
chine. The address of your closest TASKI service partner is
provided on the last page of these instructions of use.
Blade change swingo 755B/855B
• Unscrew the star knobs (1), pull the blade body (2) out of
the squeegee body and remove the blades (3).
• Now you can turn the blades or replace them.
• Put the blade body (2) back in the squeegee body and
screw the star knobs (1) back on.
1
2
3
Blade change swingo 955B/1255B
Blade in the inner radius
I
I1
X < Y
X
Y
• Put the clean squeegee body with the rolls downward on a
solid surface (table, ground, etc.). (Detail I1)
• Loosen the screw (do not remove it completely) in the mid-
dle of the 2 parts of the tightening strap until the tightening
strap can be removed. (Detail I2)
• Clean squeegee body, blades and tightening strap under
running water with a brush.
• Mount the "turned" or new blade onto the squeegee body.
• Put the tightening strap in the right position on the blade
(Detail I3).
• Tension the tightening strap. (Detail I2)
Blade on the outer radius
A
A2
A1
X < Y
X
Y
• Put the clean squeegee body with the rolls downward on a
solid surface (table, ground, etc.). (Detail A1)
• Loosen the screws (do not remove them completely) on the
left and right side of the 3-part tightening strap until the
tightening strap can be removed. (Detail A2)
• Clean squeegee body, blades and tightening strap under
running water with a brush.
• Mount the "turned" or new blade onto the squeegee body.
• Put the tightening strap in the right position on the blade
(Detail A3).
• Tension the tightening strap. (Detail A2)
I2
I3
I1
A3
A2
A1
93
EN