Battery Charging - Echo DCS-2500T Bedienungsanleitung

Battery charging

 Always use battery LBP-560-100 and charge with LCJQ-560 charger.
 Keep charger and battery away from damp conditions and all liquids.
 Do not operate the charger on an easily combustible surface (e.g. paper, textiles) or in an environment with a high
risk of fire.
 Do not cover the charger. Covering the charger will prevent it from cooling.
 Do not operate the charger in explosive atmospheres, such as in the presence of flammable liquids, gases or dust.
Charger can produce sparks which may ignite the dust or fumes - there is a risk of explosion.
 Connect the charger only to the mains of voltage and frequency specified on the rating plate.
 Connect the charger only to an easily accessible wall outlet.
 Never insert objects in the battery's or charger's cooling slots.
 Do not charge or use a defective, damaged or deformed battery and charger.
 Do not open, damage or drop the battery or the charger.
 Fluid may leak from the battery if it is damaged or not used properly; avoid contact with the skin. In the event of ac-
cidental contact, wash the affected areas of the skin with plenty of water and soap. If fluid gets in the eyes, do not
rub. Rinse the eyes with plenty of water for at least 15 minutes. Also seek medical assistance.
 Never bridge (short circuit) the battery contacts or the charger's terminals with metallic objects.
 Protect from direct sunlight, heat and open flames and never throw battery into fire; there is a risk of explosion.
 In the event of smoke or fire in the charger, disconnect it from the wall outlet immediately.
 If the connecting cord is damaged, immediately disconnect the plug from the power supply to avoid the risk of elec-
tric shock.
 Do not expose battery to microwaves or high pressure.
 Secure the unit against unintentional startup. Remove the battery from the unit before transporting or storing the
unit. Do not use metal containers for transporting batteries.
 To reduce the risk of stumbling, position and mark the connecting cord in such a way that it cannot be damaged or
endanger others.
NOTE
 The battery comes partially charged from the factory and needs to be fully charged before first use.
 Charge the battery when it no longer produces sufficient power to operate the unit or when battery lights indicate that the
battery is low.
1. Charger
2. Battery
1. Battery
2. Battery charge status
button
WARNING
3. Cooling slots
4. Charger LED
3. LED display
Before you start
1. Plug charger AC cord in the wall outlet.
2. Align ridges on battery with grooves on charger, and slide
battery into charger.
3. During normal charging, the charger LED will blink continu-
ously GREEN.
IMPORTANT
 If charger detects a problem, LED blinks RED. Remove bat-
tery from charger, clear obstructions from contacts and rein-
stall battery into charger. If battery is outside acceptable
temperature range (0°C to 60°C) LED remains RED.
4. When charging is complete, LED will remain GREEN.
∗ A fully discharged battery will charge in about 42 minutes.
5. Verify battery is fully charged by removing battery from
charger, then pressing battery charge status button, and
checking LED display.
 One green light indicates that the battery has 0-25%
charge.
 Two green lights indicate that the battery has 25-50%
charge.
 Three green lights indicate that the battery has 50-75%
charge.
 Four green lights indicate that the battery has 75-100%
charge.
6. Unplug charger AC cord from the wall outlet.
19