Sanus Systems VMAA18 Montageanleitung Seite 8

Step 4b: Attach the Arm Assembly (Part II)
Position the Arm Assembly (b) so that the hook shaped tab shown in the Detailed View of Diagram 4b is on the top. Line up the two 1"
diameter holes in the Monitor Bracket (e) at the other end of the Arm Assembly with the with the 1" Diameter Tubes (d). Continue to
push the 1" Diameter Tubes through the bracket on the Arm Assembly and then through the other Monitor Bracket. Again, make sure
the Vise Assemblies (f) on both the Arm Assembly and the second Monitor Bracket are oriented so that the 1" Diameter Tubes will pass
between the jaws. Once the 1" Diameter Tubes are in place, tighten the allen bolts on the 4 Vise Assemblies in the two Monitor Brackets
with the Allen Key (k) to lock the television to the mount. Next, slide the Arm Assembly into the desired position between the two Moni-
tor Brackets and tighten the two remaining Allen Bolts in the Vise Assemblies inside the Arm Assembly.
Note: Sanus recommends Arm Assembly to be centered between Monitor Brackets
Step 5: Attach the Wall Plate: Wood Stud only.
Warning: DO NOT OVERTIGHTEN THE LAG BOLTS! Tighten Lag Bolts (i) only until the Lag Bolt Washer (j) is pulled
firmly against the Wall Plate (a).
The Wall Plate (a) must be mounted to two wood studs at least 12" apart. Use a high quality stud sensor to locate two adjacent
studs. It is a good idea to verify where the studs are located with an awl or thin nail. Pre-drill a 2.5" deep hole in each stud at the desired
height using a 3/16" drill bit. Make sure these holes are in the center area of the studs and level with each other. Use the Wall Plate as
a template to mark the location of the second hole in each stud. Drill 2.5" deep holes using the 3/16" drill bit in each marked location.
Attach the Wall Plate to the wall using four Lag Bolts (i) and four Lag Bolt Washers (j). Make sure the Wall Plate is oriented so the flat
surface in the center of the plate is against the wall as shown in Diagram 5.
drywall cut away to show stud location
VMAA18ins_010606_ML.indd 8
Diagram 4b
b
Diagram 5
j
i a
f
e
d
stud
Detailed View
tab
1/13/06 3:04:56 PM