Troubleshooting; Safety Notices; Causes And Rectification Of Faults - Caso 3354 Bedienungsanleitung

 Exterior housing
 Clean the exterior surfaces of the device with a damp cloth.
 Turntable, grating and rolling ring
 The accessories (turntable, grating and rolling ring) must occasionally be removed and
cleaned. Wash the accessories in warm soapy water.
 The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution . Please remember to put the
rolling ring back again properly after cleaning it.
 Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

15 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

15.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

15.2 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program
will not start.
The turntable turns
jerkily.
caso HCMG 25
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Dirt between the turntable and
the base of cooking camber
Dirt on rolling ring
Cooking vessel too large
Action
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
Use different cooking vessel
77