Troubleshooting - VDO MC 2.0 WL Bedienungsanleitung

9. Troubleshooting

error
Half segments on the display
(e.g. after a battery change)
no speed displayed
no speed displayed
no speed displayed
no speed displayed
no speed displayed
Speed doubled
Display becomes weak
Display becomes weak
Incorrect altitude displayed
(current altitude incorrect)
Possible cause
Computer software not running
correctly after battery change
Distance from sensor to magnet too great
Computer not properly clicked
into the handlebar bracket
Wheel circumference is not correctly set or
is at zero
Battery in the transmitter is dead
Speed transmitter has not been paired
Magnet is incorrectly positioned
Battery dead
Temperatures under 5° make the display
sluggish
Air pressure has changed but the current
altitude has not been recalibrated in line
with the new air pressure
www.vdocyclecomputing.com www.vdocyclecomputing.com
PL PL NL NL ES ES IT IT
Correction
Take out the battery, wait a few seconds,
place battery back again
Correct the sensor and magnet positions
Place the computer head in the handlebar
bracket and twist it until it clicks
Set the wheel circumference
replace the battery in the transmitter
Insert the computer into the handlebar
bracket, speed indicator flashes, now turn
the front wheel, transmitter is paired,
speed is displayed
Correct the position of the magnet
on the spoke
Check the battery, replace if nec.
At normal temperatures the display
will work normally again
recalibrate the current altitude
FR FR ENG ENG DE DE
MC 2.0 WL MC 2.0 WL 75 75