Resetting To Factory Settings; Installation; Fitting The Transmitter, Magnet And Handlebar Bracket - VDO MC 2.0 WL Bedienungsanleitung

4.4. Resetting to factory settings

The MC 2.0 can be reset to the factory settings.
ATTENTION: this process deletes all data and all personal settings.
Press and hold all buttons simultaneously for three seconds.
B
The query FACTOrY--rESET appears on the display.
B
rESET--SUrE?

5 Installation

5.1 Fitting the transmitter, magnet and handlebar bracket

Start by fitting the transmitter and magnet.
ATTENTION: the distance between the transmitter and the computer
on the handlebars should not exceed 70 cm (transmission range).
Step 1 Place the rubber pad under the transmitter. Fit the transmitter
on the same side of the forks where you later want to fit the computer
to the handlebars (right or left) using the cable ties supplied (loosely at
first, do not pull tight just yet).
ATTENTION: the sensor mark on the transmitter must point to the
spokes. Depending on the room available, the sensor can be fitted at
the front of the forks, on the inner side (side showing to spokes) of the
forks or pointing backwards on the forks. >>> P03
If you are absolutely sure that you want to reset the MC 2.0 to the
factory settings, then confirm the query by pressing
The MC 2.0 confirms by displaying rESET--DOnE.
Step 2 Place the spoke magnet around an outer spoke. The silver
centre of the magnet points towards the transmitter. Align the magnet
to the sensor mark on the transmitter leaving a gap of about 1 - 5 mm.
Step 3 Align the transmitter and magnet for good and fasten them in
place: pull the cable ties tight and push the magnet in firmly.
Step 4 Decide whether fitting to handlebars or stem and rotate the
base of the handlebar holder by 90° accordingly. To do so, undo the
screws in the bracket, take out the foot and rotate it 90°, insert and
tighten the screws again.
ATTENTION: do not overtighten the screws.
www.vdocyclecomputing.com
PL NL ES IT FR
.
M
MC 2.0 WL
ENG DE
>>> P01
57