Motorola MULTI-UNIT-CHARGER Handbuch Seite 7

68012007024_Multi-Unit Charger.book Page 5 Monday, August 11, 2014 4:39 PM
the battery is fully charged, charger indicator changes to a STEADY
GREEN.
5. To remove a radio or battery from the charger, use two hands to remove a
radio or battery from the charger pocket. One hand to hold and support the
charger while the other hand to remove the radio or battery.
Note: Even though new batteries might prematurely indicate a full charge
(STEADY GREEN indication), charge the battery for 14-16 hours prior to
initial use for best performance. Applicable to Nickel chemistry battery
only.
Raised rail
Charging
contacts
Charger
indicator
Battery Locating Rail Adapter
The battery locating rail is a removable part which constitutes an adapter to
accommodate standard and slim batteries listed in Table 1.
The charger is shipped with the battery locating rail in the standard battery
position.
To change to the slim battery position:
1. Remove the battery locating rail by pinching inward both sides while
pulling from the charger pocket.
2. Turn the battery locating rail around so the back faces the front.
3. Re-insert into the charger pocket.
Charging
pocket
Figure 1: Multi-Unit Charger
5
Power receptacle
(located here)