Cardin Elettronica ZVL548.00 Handbuch Seite 31

ERROR SITUATIONS
• The receiver is fitted with error diagnostics. The error situations are indicated on the display by the
symbol "E" flashing followed by an error identification number.
The error numbers are as follows:
Code Message
E01 MISSING MEMORY
E02 PARAMETERS
E03 FULL MEMORY
E04 MEMORY
E05 FORBIDDEN
E06 SYSTEM
E07 PIN ERROR
E08 CORRUPT PIN
E09 SIM CODES
E10 CAR CODE
The error codes E07-E08-E09-E10 derive from functions that are only available through the use of a
PGM449 or software. Consult the instructions supplied with the specific product for more information. If
the error persists contact the after sales service.
CONNECTION PARAMETER INDICATIONS
REQUIRED:
APN SRVN SRVP
The memory chip M1 is missing or damaged
Insert or replace the memory chip M1
Receiver base parameter error
The corrupt parameters will be replaced with default values
Full memory
all memory locations have been occupied
Generic memory error
Memory access problem. Repeat the operation.
Illegal operation.
General system error.
PIN code error
The code was automatically reconstructed
The PIN code cannot be reconstructed
SIM code error
The 3G/WF card cannot be used
Remote activation code error
The function has been disabled
When the receiver starts up this indicates that one or more parameters, required
for the correct connection to the server, are missing. Each acronym indicates that
a specific parameter is missing according to the following: APN=Access Point
Name, SRVN=Gateway, SRVP=Port. The receiver parameter insertion method
is described in the CardinTX_SW software instructions.
Error description
31