Herunterladen Inhalt Inhalt Diese Seite drucken

Cardin Elettronica ZVL548.00 Handbuch Seite 23

Digitale funksteuerung mit lcd-display und 3g/wf-funktion
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 47
Table summarizing the status of the connections and the modem
When the receiver is awaiting a command an acronym, relating to the status of the modem and eventual
connections in course, will appear in brackets, in the upper right hand corner of the display.
The indications that can appear are shown in the following table:
G
Mobile network detected and connected using 2G protocol. In this condition the
data connection cannot be guaranteed as it depends on the quality of the mobile
telephone network to which it is connected.
3G
Mobile network detected and connected using 3G protocol.
?
Mobile network identification underway.
NTW
Start or close a network connection using the mobile network.
OFF
The 2G/3G/WF modem is either missing or switched off.
BSY
Start up and initialization of the modem is underway.
WF
WiFi network connected
SRV
The receiver is beginning, or has already initiated, connection to the gateway.
The letetrs will flash when CardinTX_SW software is connected.
tst
Indicates that a modem test is being carried out. The test is carried out every 60
seconds.
REQ
A call has been accepted and a connection is being made.
RMT
The receiver has set up a connection with the appliance that contacted it.
USB
Indicates that a USB connection has been activated. Activation and deactivation is
automatic each time you physically connect or disconnect the receiver from the PC.
SIM
This message can indicate one of the following situations:
- If it appears straight away on start up it indicates that the PIN code in the SIM
is corrupt;
- The SIM is not present in the modem or hasn't been detected by the modem.
Remove and reposition the SIM in its slot.
- If it appears after an attempt to initialise the modem it indicates that the PIN code
in the SIM is incorrect.
Access the menu function an reinsert the PIN code, then switch off and restart the
receiver. If the problem persists contact the after sales service.
ERR
The SIM requires a PUK code. The receiver will not allow this operation which
must be carried by a normal cell phone.
23

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis