Herunterladen Inhalt Inhalt Diese Seite drucken

Using The Marknet Print Server In Switzerland; Using The Marknet Print Server In Norway And Spain - Lexmark OptraImage Installationshandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 80
Using the MarkNet
Using the MarkNet
Using the MarkNet
Norway and Spain
24
print server in
Germany
print server in
Switzerland
print server in
In accordance with the requirements of EG 201-121, no national
network compatibility issues have been identified for the following
countries:
Austria
Belgium
Greece
Iceland
Portugal
Sweden
France
Germany
Lexmark International is required to provide the following information as
a condition of the telecommunications conformity of the Marknet print
server to Common Technical Regulation 21 (CTR). You may also be
responsible for meeting requirements other than those outlined in this
document.
The MarkNet print server requires a German billing tone filter (P/N
14B5123) to be installed on any line which receives metering pulses in
German.
The subscriber may request that metering pulses be placed on the line,
or can have them removed by calling the German network provider.
Normally, metering pulses are not provided unless specifically
requested by the subscriber at the time of installation.
Metering pulses may or may not be present on analog lines in Germany.
The MarkNet print server requires a Switzerland billing tone filter (P/N
14B5109) to be installed on any line which receives metering pulses in
Switzerland.
Metering pulses are present on all analog telephone lines in
Switzerland.
The MarkNet print server complies with all the standard DC voltage
requirements as specified in the EU standards document CTR 21.
However, the MarkNet print server does not meet the more unusual
requirements for maximum voltage in the loop state, as specified in EG
201 121 V1.1.1 advisory note NO 02 for Norway and advisory note ES
01 for Spain. In the unlikely event of low loop current, the DC voltage
may exceed the 7.4 Volt maximum.
If this occurs, the user may experience problems with the Central Office
recognizing an off-hook condition. This condition could occur in the
event that the subscriber is at the end of very long telephone lines which
are attached to older Central Office equipment.
Denmark
Finland
Ireland
Italy
United Kingdom
Switzerland
Luxemburg
Netherlands
OptraImage Setup Guide

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis