Instruction Manual - Makita DLS714 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Blade diameter
Hole (arbor) diameter (country specific)
Max. kerf thickness of the saw blade
Max. miter angle
Max. bevel angle
No load speed
Dimensions (L x W x H)
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Cutting capacities (H x W) with blade 190 mm in diameter
45° (left and right)
1. Max. Cutting capacity when using a wood facing 20 mm thickness
2. Max. Cutting capacity when using a wood facing 15 mm thickness
3. Max. Cutting capacity when using a wood facing 10 mm thickness
Symbols
The followings show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
Miter angle
0°
57° (right)
655 mm x 430 mm x 445 mm
BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /
BL1840B / BL1850 / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
45° (left)
40 mm x 300 mm
45 mm x 265 mm
(NOTE 1)
40 mm x 212 mm
45 mm x 185 mm
(NOTE 2)
–
–
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Do not place hand or fingers close to the
blade.
11 ENGLISH
DLS714
190 mm
20 mm or 15.88 mm
2.2 mm
Left 47°, Right 57°
Left 45°, Right 5°
-1
5,700 min
D.C. 36 V
12.8 - 15.2 kg
Bevel angle
0°
52 mm x 300 mm 40 mm x 300 mm
60 mm x 265 mm
(NOTE 1)
52 mm x 212 mm
60 mm x 185 mm
(NOTE 2)
52 mm x 163 mm
60 mm x 145 mm
(NOTE 3)
5° (right)
–
–
–
–
–