Specifications - Makita 5017RKB Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lever
2-1. Clamping screw
3-1. Base
4-1. Hex socket bolt (For adjusting riving
knife)
4-2. Riving knife
5-1. Retracting lever
5-2. Lock-off button

SPECIFICATIONS

Max. cutting depth
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.35 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Explanation of general view
5-3. Switch trigger
6-1. Hex wrench
6-2. Shaft lock
7-1. Inner flange
7-2. Saw blade
7-3. Outer flange
7-4. Hex socket head bolt
8-1. Dust cap
Model
Blade diameter
at 90°
at 45°
-1
)
Overall length
Net weight
Safety class
) : 93 dB(A)
pA
) : 104 dB(A)
WA
ENE028-1
Vibration
The vibration
determined according to EN60745:
ENF002-1
Work mode : cutting chipboard
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENF100-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG102-2
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
8-2. Rubber cap
8-3. Lever
9-1. Vacuum cleaner
11-1. Rip fence (Guide rule)
12-1. Limit mark
13-1. Brush holder cap
13-2. Screwdriver
5017RKB
190 mm
66 mm
46 mm
4,800
356 mm
5.5 kg
/II
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s or less
h
2
ENG214-2
vector sum)
ENG901-1