Connecting The Controller - Oase AquaMax Eco Classic 9000 C Gebrauchsanleitung

4.2 Install the unit at a dry place
 E
• Swimming pond or pool that may be accessed by people.
– Install the unit at least 2 m away from the water.
• Do not expose the pump to direct sunlight.
How to proceed:
 F
1. Remove screws.
– The screws are used as transport protection and not required for operation.
2. Actuate the engagement hook and fold up the strainer top casing.
3. Remove pump.
4. Shorten the stepped hose adapter to the diameter of the hose used if necessary.
– This reduces pressure losses.
5. Screw the stepped hose adapter including sealing ring onto the inlet.
6. Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.
– Align the stepped hose adapter prior to tightening the union nut.
7. Shorten the stepped hose adapter to the diameter of the hose used if necessary.
– This reduces pressure losses.
8. Screw the stepped hose adapter including union nut and sealing ring to the outlet.
– Align the stepped hose adapter prior to tightening the union nut.
9. Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.
4.3 Mounting the controller on the ground stake
How to proceed:
 G
1. Fully insert the ground stake into the ground.
2. Slide the device onto the ground stake.
3. Check its stability.
4.4 Mounting the controller to the wall
How to proceed:
 H
1. Affix the retaining frame using suitable screws.
2. Fit the device into the retaining frame.
– Ensure that the device is properly engaged in the retaining frame.
4.5

Connecting the controller

How to proceed:
 I
1. Remove the protection cap from the unit.
2. Attach the connector and secure with the coupling nut.
– The connector and coupling must be clean and dry.
- EN -
21