Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly Procedure
3. Display Overturn-Prevention
(1) Attach the band to the pedestal (either side is allowed)
(2) Anchor the band to the display table/rack (commercially available)
(
Screw (Black) tightening torque: 1.2 to 1.5 N•m)
(3) Anchor to the wall
Use a sturdy string, wire, or other
such commercially available item
through the hole on the display to
anchor.
[For safety reasons, always use the overturn/fall prevention accessories]
The equipment may overturn in the event of an earthquake etc. Therefore, always use the overturn/fall prevention
accessories.
* The details in this section indicate how to reduce any damage or injury caused by this equipment overturning or
falling due to an earthquake. However, there is no guarantee that the overturn/fall prevention accessories will be
effective in all earthquake situations.
(Cont'd)
Through hole on the display
Screw (Black)
(3)
(1)
(2)
Follow the operating instructions of the
display or the rack to attach.
String or wire (commercially
available), etc.
Anchor position when
attaching to the right
side
Wood screw (Silver)
Band
Surface of wall
17
Werbung
Inhaltsverzeichnis
