Disposal Information - WOLFF MAMBO EVO Originalbetriebsanleitung

The machine switches off automatically in the event of
overloading.
The LED flashes in varying intervals.
The machine has been extremely overloaded.
The machine can be restarted after some seconds.
The machine can be restarted when the LED stops flas-
hing. This indicates that the electronics have cooled and
the machine is operational.
The machine can be restarted when the LED stops
flashing. This indicates that the motor has cooled and the
machine is operational To remove load from the machine,
detach the additional weight and/or reduce the speed.
To remove load from the machine, detach the additional
weight and/or reduce the speed.
Fault Possible cause
The machine Power interrupted
does not start Fuse defective
Cable defective
Plug defective
The machine Safety switch
does not start allows the lever to
be operated only
when the handle
is tilted
The machine Overload of the
machine
does not start
The machine Overload of the
machine
does not start
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff-tools.de

9.0 Disposal information

Disposal
Overload
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
... Electronics
overheated:
nal right, power tools that are no longer usable must be
collected separately and disposed of in an environmentally
...Motor
correct manner.
overheated:
Subject to change without notice
10.0 Guarantee
Remedy
The warranty period for new Wolff machines shall last for
one year from the point at which the machine is transfer-
Contact Electrici-
red / delivered to the customer, insofar as statutory legal
an. For repair and
requirements do not stipulate otherwise.
/or replace parts
When validating warranty claims, the invoice or proof of
purchase must always be submitted.All repairs within the
framework of the warranty agreement must be undertaken
by a service Centre that has been accredited by us.
Tilt the handle of
the machine
Customers performing their own repairs and/or improper
repairs regularly lead to the exclusion of warranty claims.
The same also applies to incorrect operation and/or use.
Replacement of parts, accessories and other modifica-
Remove ad-
tions to Wolff machines
ditional weight,
work with lowered
Users of Wolff machines enjoy a high level of safety and
running gear, see
reliability of their machine. In order to maintain this status
section 3.5 Setting
quo, your Wolff tool may not be modified from the condition
the running gear
in which it is delivered without following the rules below.
Tilt the machine
These rules apply to both the replacement of parts and
over the running
equipping the machine with accessories as well as other
gear, the load on
technical modifications.
the plate is relie-
ved. Switch on the
 All work undertaken to your Wolff machine must be
machine, lower
slowly
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into natio-
EN
23