Clamping In And Adjusting The Drill - Powerfix Profi HG02905 Montage-, Bedienungs- Und Sicherheitshinweise

Keep out of the reach of children. Store the
product out of the reach of children.
Check the product for damage before each
use. Please do not use this device if you find
that it is damaged in any way.
Check that the screws are tight before each use.
Use the product on a solid, level and intact
surface (e.g. a workbench).
Always disconnect the drill from the power
supply before making adjustments or work
breaks.
The drill stand must be mounted on a work-
bench or a stable, tilt-free table, to ensure a
safe work. Use the drill holes
plate .
6
Assembly
Note: You need a 5 mm hexagon key (pro-
vided).
Connect the pillar
7
tighten the screw to fix the pillar (see Fig. A).
Then fix the slider
9
screw .
12
Mount the lever arm
Fig. B). Tighten the screws as tight as possible.
Mount the vise
13
this connect the screws with the guide slots
in the base plate through the two long slots
(see Fig. C).
Note: The vise can be positioned exactly by
moving the guide slots and long slots.
Mounting the work piece
Hold the quick-release button
pull the locking device
(see Fig. D).
Place the work-piece into the vise
Press the quick-release button and push the
locking device with the clamping jaw
against the work-piece.
Tighten the work-piece by turning the locking
device clockwise (see Fig. E).
15
6 GB
in the base
5
to the base plate and
6
on the pillar by tightening
onto the slider (see
2
onto the base plate. To do
pressed and
16
back as far as it goes
15
.
13
17
Clamping in and adjusting
the drill
Fit the drill with its clamping collar into the
drill holding fixture
(see Fig. F).
Insert a suitable drill bit into the chuck.
Unscrew screw
Move the slider
on the pillar
the work-piece.
Retighten screw
Adjusting the drill depth
Loosen the block
slider (see Fig. H).
9
Loosen the locking knob
anti-clockwise (see Fig. H).
Make sure that the bolt
doing this and slides down to the lowest
position.
Move the lever arm
the desired drill depth on the drill gauge with
indicator
11
at the same time (see Fig. I).
Make sure the bolt
sired drill depth by tightening locking knob
4
Also, fix the block
14
(see Fig. I).
Adjusting the work piece
Loosen the fixing screws of the vise
Adjust the vise with the work piece by sliding
it into position.
Mark the exact position and punch a drilling
point on the work-piece. Retighten the vise
(see Fig. J).
and tighten securely
3
(see Fig. G).
12
with the clamped in drill
9
, until the drill nearly touches
7
securely.
12
and slide it up to the
8
by turning it
10
will be released
1
down and read off
2
and tighten the locking knob
is fixed securely to de-
1
to desire drill depth
8
13
10
.
10
.