Front Panel - Yamaha A-S2200 Benutzerhandbuch

Part Names and Functions

Front panel

1 2 3
1 A (Power) switch/indicator
A (Power) switch
Power status
On
Up position
Standby
Down position Off
While the A (Power) switch is in the up position,
press the A AMP key on the remote control
repeatedly to switch the power to the unit between on
and standby mode. In addition, under either of the
following conditions, the unit will enter standby
mode.
• If the Auto Power Standby function is enabled.
(➔ page 10)
• If you turn off the power to a device that has been set to
trigger connection to this unit. (➔ page 20)
6
4 5 6
Indicator
Lit brightly
Lit dimly
Off
7
NOTICE
If you plan not to use the unit for an extended period of
time, be sure to unplug the power plug from the AC
outlet. Even when the power is turned off, a minimal
amount of electric current is still flowing to the unit.
Note
• After you turn on the unit, it will take a few seconds
before the unit can reproduce sound.
• Do not turn on the power to this unit again within
10 seconds after the power has been turned off. Doing so
may generate noise.
• While the unit is in standby mode, to turn on power to
the unit first set the A (Power) switch to the down
position to turn the power off, then set the switch to the
up position.
• While the unit is in standby mode, if you unplug the
power cable from the AC outlet and then plug it in again,
the power to the unit will be turned on.