3. INSTALLATION METHOD
3. Fasten the back plate of the wire controller
For exposed mounting, fasten the back plate on the wall with the 3 screws (M4×20)
and plugs. (Fig.3-3)
Use two M4X25 screws to install the back cover on the 86 switch box, and use one M3.9X25 screw to
fix to the wall. (Fig.3-4)
er
Back plate
NOTICE
Put on a at surface. Be careful not to distort the back plate of the wire controller
by overtightening the mounting screws.
Screws (M4×20)
Screw hole xed on the wall,useone φ
Screw hole installed on 86 switch box, use two
Fig 3-4
79
Fig 3-3
3.9X25
M3.9X25
mm
mm
5