Kaisai QSX001IU-120X2 Bedienungsanleitung Seite 113

15.Indoor unit Tx temperature query function
e
.
After the wire controller resumes the factory parameter setting, the rotating parameter
setting is restored to 10 hours (the highest and lowest temperature are not set);
The compensation of body temperature is uncompensated;
Cold and warm/single cold mode is restored to cold and warm model; The temperature
range was restored to 17 ℃~30 ℃. Remote receiving function is restored to be e ective;
The address of the two-control rst-line controller is restored to the code switch.
The buzzer is back in e ect.
When the air conditioning unit is o , into the query
function of temperature, press"
rEC. ON or OF will be displayed in the temperature
area to indicate whether it is valid or invalid.
When the selection is invalid, the wire controller
does not process any remote control signals.
Press "Con rm" into setting state, press"
or " "to select , then press "Con rm" to complete it.
When the air conditioning unit is o , into the query
function of temperature, press"
INIt, the temperature zone displayed --.
Press "Con rm" into setting state, press"
or " "to select to "ON" , then press "Con rm" to
complete it.
113
"or " "to select
"
"or " "to select
"
39