Samsung Level On Pro EO-PN920 Bedienungsanleitung Seite 570

Using the headset
Reconnecting or disconnecting device
Reconnecting the device
If the Bluetooth connection ends due to the distance between the devices, bring the devices
closer together within a certain period of time. The devices will automatically reconnect.
If the Bluetooth connection ends because of a device malfunction, use the Bluetooth menu
on the disconnected device to reconnect the devices.
Disconnecting the device
Slide the Power switch upwards and hold it for approximately three seconds. The current
connection will end and the headset will enter Bluetooth pairing mode.
You can also end the connection by turning off the headset or deactivating the Bluetooth
feature on the connected device. When you turn on the headset again and the devices are in
range, the headset automatically connects with the most recently connected device.
When the devices are connected via Bluetooth using the NFC feature, place the connected
device's NFC antenna near the NFC antenna area ( ) of the headset.
When the devices are connected via an audio cable, unplug the cable from both devices.
Noise may occur if the Bluetooth connection is disconnected improperly.
English (USA)
13
11