Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Securing to the wall
- Drill tow holes in wall and have a distance of
above 2.0m from the ground, the diameter of the
hole just contained the inflated plastic pipe, which
the diameter is 6mm.
- After tucked the inflated plastic pipe, fixed
pothook on the pipe with screw. Make sure
pothook should be inserted the bottom. See the
drawing as following for a better understanding.
(see the below picture)
315m
Ensure that the appliance is properly and safely
fixed in his working position with screws. To avoid
damaging the appliance, on recommend to use
only the holes specifically made by the manufac-
turer.
Instructions for use
Before use:
- Make sure that all the product's packaging has
been removed.
- Some parts of the appliance have been lightly
greased. Consequently, the first time the applian-
ce is used a light smoke may be detected. After a
short time, this smoke will disappear.
- To eliminate the smell given off by the appliance
when used for the first time, it is recommended
to have it on at full power for 2 hours in a well-
ventilated room.
2m
Use:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off switch.
- The appliance is on standby mode.
-The room temperature will appears on the LED
display.
- At the right side of the appliance base
-All the functions need to be operated by the
remote control.
-Press on/off from the remote control as follows:
-Pressing one time: Fan is working, the blue
twinkle light is on.
-Pressing twice: the fan keep working around
30 seconds when shutdown the appliance after
heating.
- Select the desired power.
Fan function:
- Select the fan position.
- Select the desired ventilation speed.
- Check that the thermostat button is set to the
maximum.
Heater function:
- Select the desired heating power.
- Press heating as follow: low heat (one light on)
and high heat (two light on)
- Check that the thermostat control is set to the
temperature required
Temperature setting:
- The appliance's temperature can be setting..
-Press the "+" "-" to set the temperature. The
temperature range is: 18-45ºC.
Timer function:
- The appliance's operating time can be controlled.
- To program the operating time simply select it
using the timer button from the remote control.
- Press timer button to set timer as follows:
1h,2h,3h...8h.
Oscillation function:
- The oscillation function makes it possible to
direct the flow from the apparatus
- To activate this function, press the swing button
on the remote control..
- To deactivate this function, follow the procedure
for switching it on in reverse.
Once you have finished using the appliance:
- Turn the appliance off using the on/off button
from the remote control.
- Unplug the appliance from the mains.
- Clean the appliance.
Werbung
Inhaltsverzeichnis
