Lanaform Lumi Lamp Handbuch Seite 10

EN
The model LUMI LAMP LA190109 is intended for use in the electromagnetic environment specified below. The customer or the user of model LUMI LAMP LA190109 should
assure that it is used in such an environment.
Immunity test
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.
a Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio, AM and FM radio broadcast
and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey
should be considered. If the measured field strength in the location in which the model LUMI LAMP LA190109 is used exceeds the applicable RF compliance level above,
the model LUMI LAMP LA190109 should be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as
reorienting or relocating the model LUMI LAMP LA190109.
b Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
Version 01 Lot001 - 24/06/2015
Guidance and manufacture's declaration – electromagnetic immunity –
for ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING
Guidance and manufacture's declaration – electromagnetic immunity
IEC 60601 test level
3 Vrms
150 kHz to 80 MHz
3 V/m
80 MHz to 2.5 GHz
Compliance level
3 Vrms
3 V/m
Electromagnetic environment -
guidance
Portable and mobile RF communica-
tions equipment should be used no
closer to any part of the model LUMI
LAMP LA190109, including cables, than
the recommended separation distance
calculated from the equation applicable
to the frequency of the transmitter.
Portable and mobile RF communi-
cations equipment should be used
no closer to any part of the including
cables, than the recommended
separation distance calculated from the
equation applicable to the frequency of
the transmitter.
Recommended separation distance
d = 1.167
d = 1.167 80 MHz to 800 MHz
d = 2.333 800 MHz to 2.5 GHz
where P is the maximum output power
rating of the transmitter in watts (W)
according to the transmitter manu-
facturer and d is the recommended
separation distance in metres (m).
Field strengths from fixed RF
transmitters, as determined by an
electromagnetic site survey,a should be
less than the compliance level in each
frequency range.
Interference may occur in the vicinity of
equipment marked with the following
symbol:
Lumi Lamp
10