Operation - Pettec Antibark Spray 2.0 Bedienungsanleitung

Operation

The Antibark Spray 2.0 is equipped with a rechargeable battery. The battery must be fully
charged for initial operation.
Press the power button for 2 seconds to turn on the Antibark Spray 2.0. The LED will turn
green once. The LED then flashes green every 5 seconds and signals that the trainer is
ready.
If the LED lights up red twice when the trainer is switched on, even though the battery is
charged, the trainer needs to be refilled. To do this, please turn off the trainer again, refill
the trainer with spray and switch it on again.
To turn off the Antibark Spray 2.0, press the power button for 2 seconds until the LED lights
up green several times.
To set the sensitivity of the trainer, press the Adjust button. The trainer is factory-set and
shipped with the lower sensitivity setting.
As a result, when you press the Adjust button for the first time, the sensitivity level
changes from low to high. This causes the LED to glow red. When you switch back to the lower
sensitivity setting, the LED glows green.
18
Turn on
Sensitivity levels
Turn on