Operation Guide - Pettec Remote Vibra Advance 2.0 Bedienungsanleitung

Operation guide

Remote control
The blue backlight on the display stays on for approximately 30 seconds after a button
press. After that with no button press, the blue backlight shuts off first, and if no button is
pressed within another five minutes, the display shuts off and the remote control goes into
battery condervation mode. Pressing any button will turn the display back on.
Trainer
To turn the trainer on, press and hold the On/Off button until the green LED light comes on.
Release the On/Off Button and if the trainer is in normal mode, the green LED will flash
once every five seconds, indicating the trainer is on and ready to receive a signal from
the remote control. To turn the trainer off, press and hold the On/Off button until the red
LED light shuts off. (This takes approximately three seconds) After that release the On/
Off button.
23