Charging the Antibark Spray 2.0
With the aid of the charging cable, fully charge the Antibark Spray 2.0 until the LED is
permanently lit green. As long as the LED is red and green, the device is not fully charged.
Charging the trainer:
Open the rubber cover on the underside of the Antibark Spray 2.0 and plug the USB
•
charging cable into the jack.
Then, connect the USB port to the adapter and plug the charger into an outlet.
•
A full charge cycle takes about 2 hours.
•
The Antibark Spray 2.0 can be charged with any commercially available micro USB
•
charger.
23