IARP SMART N.3 I-P M ES Gebrauch Und Bedienung Seite 15

For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: Wash with warm water and mild detergent, rinse well and dry
with soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: Wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: Only use products specifically designed for glass cleaning; It is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
DEFROSTING AND TANK CLEANING
To always achieve the highest performance we recommend a manual defrosting when the frost layer
on the tank walls exceeds 5 mm thickness. For tank cleaning proceed as follows:
1) Place the goods in special refrigerated containers, kept at the same temperature and remove the
shelves
2) Unplug the unit
3) Leave the doors open and begin the operation of tank washing when the tank temperature is the
same as the ambient temperature.
4) Clean and dry the interior of the tank with a soft cloth, using neutral soap.
Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Warning! Do not use jet of water or steam to clean the cabinet: electrical wiring could be
damaged.
Warning! Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
MALFUNCTIONS AND REMEDIES
Most of the functioning inconveniences are generally due to defective electrical connections.
These problems can usually be solved on the place.
The unit does not start:
-check that there is voltage at the wall socket;
-check that the unit is properly plugged.
The internal temperature is not cold enough:
-check that the unit is not placed too close to any heating source;
-check the temperature setting;
-check that behind the cabinet air can properly circulate;
-check the perfect closing of the glass door
The unit is noisy:
-check that all the bolts and nuts are properly fasten;
-check that the unit is placed on an even surface;
-check if any pipe or fan is in contact with any other part of the body.
INFORMATIONS ABOUT SERVICE
-15-