Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting the Lens
Caution:
Before you mount the lens, loosen the two screws
on the ring, and rotate this ring clockwise until it
stops. If the ring is not at the end, the inner glass
or CCD image sensor may be damaged.
1. Mount the lens by turning it clockwise on the lens
mount of the camera.
2. Connect the lens cable to the auto iris lens con-
nector on the side of the camera.
2
Back Focal
Adjusting Ring
Screws
1
-8-
Caution for Mounting the Lens
The lens mount should be a CS-mount (1"-32UN) and
the lens weight should be less than
the lens is heavier, both the lens and camera should
be secured by using the supporter.
The protrusion at the rear of the lens should be as
shown below.
CS-mount: Less than 8 mm (5/16")
450g (0.99 lbs). If
Werbung
Kapitel
