Machine Settings - Electrolux TW SL EEV Benutzerinformation

58 electrolux

Machine settings

Setting
Buzzer permanent
on/off
1)
Water hardness
Emptying water res-
ervoir - warning
2)
off
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according
to geographical locations thus varying its conductivity values. Relevant variations of the conductivity
of the water compared to those prefixed by the factory could slightly influence the residual humidity
of the laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying
sensor based on conductivity values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water
reservoir is full. When using an external drain for the condensed water warning can be offi
1. Turn the programme selector to any programme.
2. Press simultaneously the Dryness (Trockengrad) and Spin Speed (U/Min)
buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use the buzzer option to
activate or deactivate sound but the machine does not memorise your
selection.
1. Turn the programme selector to any programme.
2. Press simultaneously the Dryness (Trockengrad) and Time (Zeitwahl) but-
tons and hold down for approx. 5 seconds. The current setting is on the
display:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
3. Press the Start/Pause button sequentially until you set desired level.
4. To memorise setting press simultaneously the Dryness (Trockengrad) and
Time (Zeitwahl) buttons or turn knob to Off (Aus) position
1. Turn the programme selector to any programme.
2. Press simultaneously the Spin Speed (U/Min) and Time (Zeitwahl) buttons
and hold down for approx. 5 seconds.
The current setting is on the display:
– warning
icon and
– warning
icon and
Implementation
- warning message is off
- warning message is switched on