Care And Cleaning - Electrolux TW SL EEV Benutzerinformation

54 electrolux
Starting the programme
Press the Start/Pause button (6). The programme
is started.
The programme progress is shown in LCD by ap-
propriate set of icons. From left to the right, from
iron dry to anti-crease
drying cycle chosen. E. g. in case of cupboard
dry programme the following status icons are visi-
ble:
marked by flashing dash under status icon. When
appropriate part of drying cycle is accomplished
dash becomes steady and appears flashing under
next status icon.
Changing programme
To change a programme which has been selected
by mistake once the programme has started, first
turn the programme selector to Off (Aus) and then
reset the programme.
The programme can no longer be changed
directly once the programme has started. If
nevertheless there is an attempt to change the
programme on the programme knob, the pro-
gramme progress display and the maintenance in-
dicators flash. If an option (excluding the buzzer )
is set, Err appears in the multidisplay. The drying
programme is not however affected by this (laun-
dry protection).
Programme complete / Laundry unloading
Once the drying cycle is complete, display shows
a blinking , under anti-crease

Care and cleaning

Emptying the water reservoir
Empty the water reservoir after every drying cycle.
Warning! The condensed water is not
suitable for drinking or for preparing
foodstuffs.
icon depends on the
. Current cycle progress is
icon appears
dash. If the buzzer option has been set, an acoustic
signal sounds intermittently for about one minute.
The drying cycles (except for the Wool (Wolle)
programme) are automatically followed by an
anti-crease phase which lasts around 30 minutes.
The drum rotates at intervals during this phase.
This keeps the laundry loose and free of creases.
The laundry can be removed at any time during the
anti-crease phase. (The laundry should be taken
out towards the end of the anti-crease phase at
the latest to prevent creases from forming.) If long
anti-crease option has been set, the anti-
crease phase is lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove fluff from
the micro-fine filter. It is best to use a damp
hand for this purpose. (See "Care and clean-
ing" chapter.)
3. Remove laundry.
4. Turn the programme selector to Off (Aus).
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Care and cleaning".)
5. Close the door.
If the programme has been interrupted as a
result of the water reservoir being full: Press
the START PAUSE button to continue the drying
cycle.
Cleaning fluff filters
The filters collect all the fluff which accumulates
during drying. To ensure that the dryer works per-
fectly, the fluff filters (micro-fine filter and fine strain-
er) must be cleaned after every drying cycle.