First Operation - Safescan 2265 Bedienungsanleitung

English

First operation

2. Set the banknote hopper guide so that the sides of the banknotes are enclosed and therefore the banknotes are
centered. Organise your banknotes in a neat stack, make sure the back of the stack is aligned straight and the notes
are centered.
1
First, place the stack of banknotes facing forward
on the hopper (1).
Not following these steps may result in counting errors.
3. When the device detects a suspect banknote during counting, it will stop, sound an alarm and display an error
message. The last counted banknote in the stacker is the suspect note. Remove this note and press [Start/OK]
to continue counting.
When an error message has occurred, it is recommended to re-count the complete stack of banknotes to
verify the counting result.
6
1. The Safescan 2265 starts by default with the following settings:
BATCH
A. Currency: EUR
B. Counting mode: MIX
MODE C. Auto start: ON
Note: to switch to GBP currency, press [DETECT].
DETECT
More info, articles, tutorials and videos at: support.safescan.com
START
OK
CLR
2
Then, flip back the stack to start counting (2).