JANE BABYSIDE Bedienungsanleitung Seite 13

3) Rest the bar on the supports designed for this purpose.
4) Move the cot close to the parents' bed and check the height of the cot compared to the adult bed. Use the two
additional straps supplied with the co-sleeping cot to fasten it to the adult bed.
*Note: In co-sleeping mode the two cot legs should be set to the same height position.
5) Fasten the black clasp on the additional strap to the clasp on the base frame, under the fabric cover. The red clasps
on the strap should be facing upwards.
"click"
6) Pass the free end of the strap underneath the structure of the adult bed (A) and wrap it round to fasten the free
end of the red clasp with the red clasp positioned closest to the BABYSIDE cot (B).
A B
*
1
2 STOP
*
*Note: For easier installation, keep the cot slightly separated from the adult bed and then move it closer by tightening
the straps.
If the retractable legs touch a bed structure that reaches the floor, the legs will retract as the co-sleeping cot gets
closer to the adult bed using their telescopic system, lock the wheels in this position.
7) Move the BABYSIDE co-sleeping cot closer and tighten the straps by pulling the free end firmly.
OK NO
MATTRESS MATTRESS
5 5
2 2
1 1
*Note: Before using the cot, make sure there is no gap between the parents' mattress and the side rail of the BABY-
SIDE co-sleeping cot.
8) Lock the wheels using the brakes fitted on them as explained in the 'Assembling and dismantling the co-sleeping
cot' section.
13