Operation Mode Fm Radio; Operation Mode Bluetooth Playback - Omnitronic DJP-900NET Bedienungsanleitung

Operation mode FM radio

To receive the ordinary FM stations, connect the supplied wire antenna to the antenna jack on the rear
panel. Place the receiver close to a window and extend the antenna as far as possible for the best possible
reception.
Navigate to the main menu and select the menu item FM Radio or use the MODE button on the remote
control to switch the operating mode to FM Radio. Confirm with OK.
The received channels are indicated in the display:
You can now select a channel. If you wish to add the channel to your Favourites, press the button
▼
Use the button ◄ (or
Note: While you are using FM Radio you have access to further information about the radio station currently
playing. With the button ► you can scroll through the pages. Each page gives you a different piece of
information such as frequency and time.
Manual tune
To tune to the frequency manually, keep OK (or TUNE/SELECT on the unit) pressed until Tuning appears at
the bottom right corner of the display. Use the rotary dial or the buttons ◄ and ► to adjust the frequency.
Keep OK pressed to exit the menu.

Operation mode Bluetooth playback

Before transmission between your Bluetooth device and receiver is possible, the two devices must be
coupled. This procedure is called "pairing". The receiver serves as server receiving and playing the streamed
music. If the receiver has been paired with a Bluetooth device before, this connection will be restored
automatically when both devices are in range and Bluetooth has been enabled on both devices. The pairing
does not have to be repeated.
Bluetooth ON
For the initial pairing with a Bluetooth device, proceed as follows:
• Press the button MENU and use ▲ and ▼ to select the operating mode Bluetooth.
• Activate discovery mode of the Bluetooth device. Now the device scans for other devices with enabled
Bluetooth within its reception area.
• When the device has recognized your receiver, its display indicates "DJP-900NET".
• Select your receiver from the list.
Start playback at the Bluetooth device.
•
on the unit) to go back to this menu.
a
DJP-900NET
b
34 • EN
.
c