Removal Procedure - Panasonic AV-HS04M8 Bedienungsanleitung

Mounting
Checking that the board has been mounted correctly
Turn on the power of the AV-HS450 (to both the control panel and mainframe), and use
the menu for displaying the statuses of the option boards to check that the board has
been mounted correctly.
 Press the [SYSTEM] button to light its indicator, to display the SYSTEM menu.
 Turn [F1] to display the OptVer sub menu.
<Menu display>
13 | Select | Board
SYS
OptVer |
 Turn [F2] to select the option slot (SLOT A or SLOT B) using the Select item.
If the board has been mounted correctly, "DVID-IN" will appear at the Board item.
If it has not been mounted correctly, "None" will appear at the Board item.
For details on the input signal settings and operating methods, refer to the operating
instructions in CD-ROM of the AV-HS450.
4-2. Setting the DVI input signals
5-2. Setting the crosspoints
If the vertical frequency of the DVI-D input signal and the vertical frequency of the system format
are different, conversion may not be performed smoothly for moving images, as the frame rate will
change when converting the DVI signal to the system's video signal.

Removal procedure

Remove this board by following the procedures for mounting it in reverse.
 When attaching the blank panel, position the panel so that the part with the protrusion
is facing down, and then attach it.
| Version |
SLOTA|DVID-IN|
SLOTB
0001|
10 (E)