Inhaltsverzeichnis
Werbung
Before using, be careful never to transmit without fi rst having con-
nected the antenna (connection "B" situated on the back panel of
the equipment) or without having set the SWR (Standing Wave Ratio)!
Failure to do so may result in destruction of the power amplifi er,
See function "F" on page 19 and the Confi guration table on page 51.
The guarantee of this transceiver is valid only in the country of purchase.
Welcome to the world of the new generation of CB radios. The new PRESIDENT range gives you access
to top performance transceiver equipment. With the use of up-to-date technology, which guarantees
unprecedented quality, your stabo xm 3006e 12/24V is a new step in personal communication and
is the surest choice for the most demanding of professional CB radio users. To ensure that you make
the most of all its capacities, we advise you to read carefully this manual before installing and using
your stabo xm 3006e 12/24V.
A) INSTALLATION
1) WHERE AND HOW TO MOUNT YOUR MOBILE CB RADIO
a) You should choose a well ventilated place most appropriate setting from a simple and practical
point of view.
b) Your CB radio should not interfere with the driver or the passengers.
c) Remember to provide for the passing and protection of different wires (e.g. power, antenna,
accessory cabling) so that they do not in any way interfere with the driving of the vehicle.
d) To install your equipment, use the cradle (1) and the self-tapping screws (2) provided (drilling
diameter 3.2 mm). Take care not to damage the vehicle's electrical system while drilling the dash
board.
e) Do not forget to insert the rubber joints (3) between the CB and its support as these have a
shock-absorbing effect which permits gentle orientation and tightening of the set.
f)
Choose where to place the microphone support and remember that the microphone cord must
stretch to the driver without interfering with the controls of the vehicle.
-
N.B.: As the transceiver has a frontal microphone socket, it can be set into the dash board. In
this case, you will need to add an external loud speaker to improve the sound quality of com-
munications (connector EXT SP situated on the back panel: C). Ask your dealer for advice on
mounting your CB radio.
WARNING !
which is not covered by the guarantee.
MULTI-NORMS TRANSCEIVER!
15
Werbung
Inhaltsverzeichnis
