Microphone Connection - stabo xm 3006e VOX 12/24 Bedienungsanleitung

External speaker
The stabo xm 3006e VOX 12/24 is equipped with a connection (C) for an external speaker
with an impedance of 8 W.
You can connect a speaker with a 3.5 mm mono jack plug to improve reproduction. Install the
speaker so that it cannot injure you or your passengers in case of an accident.

Microphone connection

Connect the supplied microphone to the microphone connection at the front left of the device.
Make sure that the recess on the plug connector points down.
Country programming
The stabo xm 3006e VOX 12/24 has six different channel configurations.
In Germany this device is not subject to compulsory registration or fees.
Before you use your radio device abroad, familiarise yourself with the regulations in the
respective countries and register the device as necessary.
The frequency band and transmission power of your device must match the national
regulations in the country in which it is being used.
40 FM (4 W), 40 AM (4 W)
EU
40 FM (4 W), 40 AM (4 W)
PL
With a carrier offset of -5 KHz
80 FM (4 W), 40 AM (4 W)
d
40 FM (4 W)
EC
40 FM/AM (4 W) CEPT
U
40 FM (4 W) MPT 1382
40 FM (4 W), 40 AM (4 W)
rU
With a carrier offset of 0/-5 KHz, switchable
Not subject to compulsory registration or fees in BE, CH, CY, DE, DK, EE, IS, LT, LU, NO,
1)
PT, SE
Subject to compulsory registration or fees in ES, IT
Only permitted in PL
2)
Not subject to compulsory registration or fees in DE, CZ,SK
3)
Use approved in all CEPT states, subject to compulsory registration in individual countries
4)
Only permitted in GB
5)
Permitted in Russia
6)
In order to switch the configuration, proceed as follows:
1. Switch off the radio device.
2. Press and hold the F key 7.
3. Switch the radio unit back on again.
The previously used channel configuration then flashes on the display screen.
4. Now select one of the six configurations using channel switch 4.
5. Press and hold the F key for approximately 1 second until the display stops flashing.
6. Switch the device off and back on again.
The device is then ready for operation with the new channel configuration.
(7)
1)
2)
3)
4)
5)
6)
20